Product Feature

Although it tends to seem that end mill is held by Milling Chuck, it is not enough as rigidity that Milling Chuck has just high holding power. Super G1 Chuck is a high rigidity tool holder strong against horizontal influence.

Product Feature

Super G1 Chuck has guaranteed the comprehensive run-out accuracy in the state where the collet was set. Moreover, it set to the system and is very stable also about dynamic run-out accuracy, and there is little wear of tool and it can perform reduction of tool expenses.

Product Feature

Green G1 chuck makes it possible to change the feed speed fast at the end mill processing. Cycle time is shortened and it contributes to improvement your productivity.

Product Feature

YHL flange type clamp set is a special-purpose machine without the turret and ATC of NC lathe, and is the unit which can carry out manual exchange of the HSK holder easily.

Product Feature

Direct Drive CNC Rotary Table DRC170 has achieved high speed rotation and zero backlash furnished with a built-in direct drive (DD) motor. This series is available for machining wide range of products such as parts for automobiles and IT related products.

Product Feature

CNC Rotary Table JNCH Series will contribute to improve your productivity by shortening the indexing time. Max rotation speed of JNCH140 is 83.3 min^-1, and JNCH170 is 66.6 min^-1.

Product Feature

Collet adaptor CA series are simple unit that makes the spring collet open and close by manually tighten and loosen the collet cap with the attached lever. The way to open and close the chuck is easy.

Product Feature

Flange center FC series are a rotating assisting device with a work driving dog. It is a flange that is used set to the table face to support the edge of a work piece with 60°center hole and rotate the work piece with the dog.